Wireless M2T stereo transmitter, M2R stereo receiver with 3.5 mm 
line-in jack and EP3 in-ear dynamic headphones with 3 sizes of rubber earpieces 
plus ear-conforming foam tips.
The M2 Wireless In-Ear Monitor System is designed to make professional in-ear 
monitoring features accessible for performers who want to be free from the 
problems associated with floor wedges. The stereo monitor system offers Personal 
Mix Control, which gives each musician volume and mix control of two independent 
signals on stage, via easy-to-use controls on the M2R stereo body-pack receiver. 
The wireless UHF M2T Stereo Transmitter provides a choice of 100 selectable 
frequencies and is equipped with two XLR/¼” combo input connectors into which 
users can connect line-level inputs. While up to 10 complete M2 systems may be 
used on stage simultaneously, any number of M2R stereo receivers may be used on 
the same frequency with a single M2T stereo transmitter. These rugged systems 
are built to stand up to the inevitable bumps of life on the road, delivering 
clear, natural sound for touring and installed-sound uses.
Features:
	- High-fidelity sound with clean, articulate mix 
	allows you to hear yourself better at lower volume
 
	- 100 selectable UHF channels
 
	- Up to 10 simultaneous systems per frequency band
	 
	- Three receiver modes: Personal Mix, stereo, and mono
	 
	- Personal Mix Control allows volume and mix control 
	of two independent signals at the receiver
 
	- 3.5 mm line-in jack connects to ambient microphone, 
	click track & more
 
	- LED indicators provide easy-to-read level monitoring
	 
	- XLR loop output (true pass-through) connects signal 
	to mixing console, additional IEM system or recording device with no signal 
	degradation
 
	- Adjustable squelch eliminates annoying static
	 
	- Pilot tone protects against RF interference when the 
	transmitter is turned off
 
	- Limiter (defeatable) helps protect your hearing from 
	sudden peaks
 
	- Portable system is quick to load and set up
 
	- Reduces on-stage audio clutter for better overall 
	mix & less feedback
 
	- Use any number of M2R Stereo Receivers (with 
	Personal Mix Control) on the same frequency
 
	- Audio-Technica earphones with proprietary dynamic 
	drivers offer full frequency response and outstanding isolation
 
	- Personal fit with 3 sizes of rubber eartips plus 
	ear-conforming foam tips
 
	- Auxiliary input offers connection point for ambient 
	microphone, click track, or other mic- or line-level input.
 
Specifications:
	
		| 
		RALL SYSTEM SPECIFICATIONS | 
	
	
		| 
		Operating Frequencies | 
		
		Band E: 790.000 to 822.000 MHz, 100 frequencies  
		Band F: 832.000 to 865.000 MHz, 100 frequencies  
		Band L: 575.000 to 608.000 MHz, 100 frequencies  
		Band M: 614.000 to 647.000 MHz, 100 frequencies  
		Not all frequency bands available in all areas. Please check with 
		local regulations. | 
	
	
		| 
		Minimum Frequency Step | 
		
		25 kHz | 
	
	
		| 
		Modulation Mode | 
		
		FM stereo | 
	
	
		| 
		Maximum Deviation | 
		
		±40 kHz | 
	
	
		| 
		Dynamic Range | 
		
		90 dB (typical), A-weighted | 
	
	
		| 
		Total Harmonic Distortion | 
		
		<1% at (1 kHz, ±20 kHz Deviation) | 
	
	
		| 
		Operating Range | 
		
		100 m (300'), typical  
		Open range environment with no interfering signals.
  | 
	
	
		| 
		Operating Temperature Range | 
		
		-5° C (23° F) to +50° C (122° F)  
		Battery performance may be reduced at very low temperatures. 
		 | 
	
	
		| 
		Frequency Response | 
		
		60 Hz to 13 kHz (+/- 3 dB) | 
	
	
		| 
		Simultaneous Use | 
		
		10 channels per band (maximum recommended)  
		For assistance with multi-band operation or other frequency 
		coordination issues, please contact your local Audio-Technica customer 
		service representative.
  | 
	
	
		| 
		RECEIVER SPECIFICATIONS | 
	
	
		| 
		Receiving System | 
		
		Double conversion superheterodyne | 
	
	
		| 
		RF Sensitivity | 
		
		20 dBuV (at 60 dB S/N ratio, 50 ohms termination) | 
	
	
		| 
		Headphone Output Connector | 
		
		3.5 mm TRS stereo phone jack | 
	
	
		| 
		Headphone Output Power | 
		
		65 mW (at 32 ohms) | 
	
	
		| 
		Antenna Input | 
		
		SMA-type, 50 ohms | 
	
	
		| 
		Aux Input Connector | 
		
		3.5 mm TRS stereo phone jack | 
	
	
		| 
		Batteries | 
		
		2 x 1.5V AA (not included) | 
	
	
		| 
		Battery Life | 
		
		8 hours (alkaline)  
		Depending on battery type and use pattern | 
	
	
		| 
		Dimensions | 
		
		70.0 mm (2.76") W x  25.0 
		mm (0.98") D x  110.0 mm 
		(4.33") H | 
	
	
		| 
		Net Weight | 
		
		110 g (3.9 oz), without batteries | 
	
	
		| 
		Accessories Included | 
		
		EP3 earphone; frequency sticker; flexible antenna | 
	
	
		| 
		TRANSMITTER SPECIFICATIONS | 
	
	
		| 
		RF Power Output | 
		
		10 mW/30 mW (switchable internally), 50 ohms  
		Limited to 10 mW within 863 MHz to 865 MHz  
		Following national regulations | 
	
	
		| 
		Spurious Emissions | 
		
		Following federal and national regulations | 
	
	
		| 
		Input Connections | 
		
		XLRF-type/6.3 mm stereo (1/4") combination connector  
		Pin 1 and Sleeve: Ground  
		Pin 2 and Tip: Hot  Pin 3 
		and Ring: Cold | 
	
	
		| 
		Maximum Input Level | 
		
		XLRF-type/6.3 mm stereo, (1/4") balanced: +26 dBu  
		6.3 mm (1/4") mono, unbalanced: +26 dBu | 
	
	
		| 
		Loop Output Connector | 
		
		XLRM-type connector  Pin 
		1: Ground  Pin 2: Hot  
		Pin 3: Cold | 
	
	
		| 
		Power Requirement | 
		
		12-18V DC, 600 mA | 
	
	
		| 
		Antenna | 
		
		Attached whip | 
	
	
		| 
		Dimensions | 
		
		210.0 mm (8.30") W x  
		132.0 mm (5.20") D x  44.0 
		mm (1.70") H | 
	
	
		| 
		Net Weight | 
		
		870 g (30.7 oz), without accessories | 
	
 Download Instruction Manual
Would you like to help others by submitting a review? Create an account and earn points for your reviews!